• New Plywood Exterior Grade will be used to cover the entire strapped roof deck, (only done for conversion from cedar shakes to fiberglass laminated asphalt shingles)
• We use Certainteed Diamond Deck which is a premium breathable, exceptionally strong with long-lasting protection.

• Pre-painted metal drip edge flashing along the gable ends, 4 different colors available.
• Pre-painted metal W shaped flashing which is 24 wide is used in valleys, 4 different colors available.
• Pre-painted metal flashing around chimneys & skylights

• Attic vents at peak or Continuous Ridge Venting. The vents let the air circulate into the attic space. This helps to remove all heat and moisture. Different colors are available to match your roof.
• Goose Neck Vents
• Exhaust Vents, BVents & Plumbing Vents

• A 24 EPDM rubber membrane which is fully bonded to the roof deck
• New Copper drains allow the water from the gutters to pass through the soffits down the pipes. Pre-painted metal cap flashing is installed on the top of the fascia board. This is available in 4 different colors.

• We use Shingle Match spray paint for the finishing of the B- Vent pipe and chimney counter flashing.

The final touches to your roof would be:

• To install diverters on Fascia board tail ends, (this helps to change the direction of the rain flow into the gutters.)
• Use of a powerful magnetic broom to pick up any loose nails and a final clean-up to customer satisfaction.